LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 816 (Front Suspension System) >> Repair Instructions >> Lower Control Arm Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the control arm to the frame.
    2. Fig 1: Control Arm-To-Frame, Bolts & Nuts
    GM929911Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install new control arm-to-frame rear bolts and nuts.

    Tighten:  Tighten the nuts to 70 N.m (52 lb ft).

  3. Install a new arm-to-frame front bolt and nut.

    Install new control arm-to-frame rear bolts and nuts.

    Tighten:  Tighten the bolt to 200 N.m (148 lb ft).

    4. Fig 2: View Of Lower Ball Joint Stud Cotter Pin & Nut
    GM929893Courtesy of GENERAL MOTORS CORP.
  4. Install the control arm ball stud into the steering knuckle.
  5. Using the SA9140E  , install the ball stud nut.

    Tighten:  Tighten the nut to 40 N.m (30 lb ft).

    6. IMPORTANT:
    • Do not loosen the castle nut, only tighten to align the ball stud slot.
    • Ensure that the cotter pin ends do not contact the ABS sensor harness or drive axle.
  6. Continue to tighten the nut only enough to align the castle nut slots with the ball stud, install the cotter pin.
  7. Install the wheel and tire assembly. Refer to Tire and Wheel Removal and Installation .
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals