LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> STS V >> Repair and Diagnosis >> External Pages >> Different car >> Section 336 (Keyless Entry System And Remote Functions) >> Repair Instructions >> Remote Control Door Lock Receiver Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac XLR. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Remote Control Door Lock Receiver & Screws
    GM1231031Courtesy of GENERAL MOTORS CORP.
  1. Connect the receiver connector and route the wire harness through the I/P carrier.
  2. Line up the receiver with the hole on the retainer.
    3. NOTE: Refer to Fastener Notice .
  3. Install the retaining screws to the remote control door lock receiver.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

  4. Install the I/P trim pad. Refer to Instrument Panel Trim Pad Replacement .
  5. Perform the RCDLR programming and setup procedure. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals