Installation Procedure

Fig 1: View Of DIC Switch Pod

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the DIC switch retaining screws.
Tighten: Tighten the screws to 1.5 N.m (13 lb in).

Fig 2: View Of Ignition Switch & Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the DIC switch electrical connector.
Install the retaining screw at the bottom of the DIC switch pad.
Tighten: Tighten the screw to 1.5 N.m (13 lb in).
Install the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement .