LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> XLR Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Front End Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Front End Sensors
    GM1267620Courtesy of GENERAL MOTORS CORP.
  1. Remove any dirt, grease, or other impurities from the mounting surface (7).
  2. Position the sensor (3, 4) horizontally on the mounting surface.
  3. Point the arrow on the sensor toward the front of the vehicle.
    4. NOTE: Refer to FASTENER NOTICE .
  4. Install the mounting fasteners (8, 9).

    Tighten:  Tighten the fastener (1) to 9 N.m (80 lb in).

  5. Connect the harness wiring connector (2, 5) to the front end sensor (3, 4).
  6. Install the CPA (1,6) to the wiring harness connector on the front end sensor.
  7. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals