LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> XLR Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Side Impact Module Replacement - Front >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new inflatable restraint side impact module bracket.
    2. CAUTION: Following the deployment of a side impact air bag, replace the inflator module bracket to the air bag. Failure to do so may cause future personal injury.
    NOTE: Refer to Fastener Notice .
  2. Install the 2 bracket mounting bolts to the module.

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

    3. Fig 1: View Of Inflatable Restraint Side Impact Module Electrical Connector
    GM792283Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector (1) to the inflatable restraint side impact module.
  4. Install the CPA to the module electrical connector.
  5. Install the module to the seat.
    6. Fig 2: Locating Inflatable Restraint Side Impact Module Bracket Bolts
    GM792279Courtesy of GENERAL MOTORS CORP.
  6. Install the 2 bolts (1) to the inflatable restraint side impact module.

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

  7. Install the seat back trim. Refer to Front Seat Back Trim Replacement .
  8. Enable the SIR system. Refer to SIR Disabling and Enabling .
  9. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping .
scientia non olet · About LEMON Manuals