Liftgate Close Actuator Motor Control Module Replacement

WARNING: This page is about a different car, the 2008 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Liftgate Close Actuator Motor Control Module

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the body side trim panel. Refer to Body Side Rear Trim Panel Replacement (w/TB5) or Body Side Rear Trim Panel Replacement (w/o TB5) . Disconnect the power liftgate actuator rod. Refer to Liftgate Actuator Rod Replacement .
1	Liftgate Close Actuator Motor Control Module Bolt (Qty: 5) NOTE: Refer to Fastener Notice . Procedure Disconnect the electrical connector. Cut the tie strap, if equipped. Tighten: 9 N.m (80 lb in)
2	Liftgate Close Actuator Motor Control Module Procedure: If a replacement control module is installed, program the module. Refer to Control Module References .

Callout

Component Name

Preliminary Procedures

Remove the body side trim panel. Refer to Body Side Rear Trim Panel Replacement (w/TB5) or Body Side Rear Trim Panel Replacement (w/o TB5) .
Disconnect the power liftgate actuator rod. Refer to Liftgate Actuator Rod Replacement .

Liftgate Close Actuator Motor Control Module Bolt (Qty: 5)

NOTE: Refer to Fastener Notice .

Procedure

Disconnect the electrical connector.
Cut the tie strap, if equipped.

Tighten: 9 N.m (80 lb in)

Liftgate Close Actuator Motor Control Module
Procedure:
If a replacement control module is installed, program the module. Refer to Control Module References .