Circuit/System Testing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the GPS and cell coax cable connector at the vehicle communication interface module.
- Using the EL-49903-3 kit (EL-49903-5 adapter and EL-49903-4 coax cable), connect the EL-49903 kit to the vehicle communication interface module, place the test antenna on the roof of the vehicle.
- Ignition ON, wait 5 minutes, then contact the OnStar call center consultant by pressing the blue OnStar button. A call center consultant should answer the call, ask the consultant to verify the vehicle location to confirm the GPS system is functioning.
- If the OnStar GPS does not function, replace the vehicle communication interface module.
- Reconnect the coax cable to the vehicle communication interface module. Disconnect the coax cable from the navigation antenna.
- Test for 4.5-5.5 V between the coax cable center conductor and the outer shield.
- If not within the specified range, replace the coax cable.
- If all circuits test normal, replace the navigation antenna.