LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2008 >> XLR Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 4.4L - Introduction) >> Repair Instructions >> Accelerator Pedal Position Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Accelerator Pedal
    GM931700Courtesy of GENERAL MOTORS CORP.
  1. Install the accelerator pedal to the steering column support bracket.
    2. NOTE: Refer to Fastener Notice .
    IMPORTANT: Always use a torque wrench in order to obtain the proper torque.
  2. Install the accelerator pedal mounting bolts (1).

    Tighten:  Tighten the accelerator pedal mounting bolts to 10 N.m (89 lb in).

    3. Fig 2: View Of Accelerator Pedal Sensor Module Electrical Connector
    GM1252542Courtesy of GENERAL MOTORS CORP.
  3. Connect the accelerator pedal sensor module electrical connector (1).
  4. Check for correct carpet fit under the accelerator pedal.
  5. Install the left I/P on the lower closeout insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
scientia non olet · About LEMON Manuals