LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2009 >> CTS V, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 6.2L - Introduction >> Repair Instructions >> Fuel Injection Fuel Rail Assembly Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the front and rear intake manifold covers. Refer to Intake Manifold Cover Replacement - Rear .
  3. Relieve the fuel system pressure. Refer to Fuel Pressure Relief (Without CH 48027)  or Fuel Pressure Relief (With CH 48027) 
  4. Disconnect the fuel pipe from the fuel rail. Refer to Metal Collar Quick Connect Fitting Service
    5. Fig 1: Identifying Connectors
    GM2164120Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the fuel injection Harness connectors (1, 2).
  6. Disconnect the BARO sensor harness connector (5).
  7. Disconnect the intake temperature sensor harness connector (4).
  8. Disconnect the supercharger air outlet pressure sensor harness connector (3).
    9. Fig 2: Identifying Ignition Coil Harness Connector
    GM2157868Courtesy of GENERAL MOTORS CORP.
  9. Disconnect all 8 ignition coil harness connectors (1).
    10. Fig 3: Identifying Fuel Rail Ball Stud Fasteners
    GM2164123Courtesy of GENERAL MOTORS CORP.
  10. Remove the front fuel rail fastener.
  11. Remove the fuel rail ball stud fasteners (1).
  12. Carefully disengage the fuel injectors from the supercharger.
  13. Remove the fuel rail wit the fuel injector harness from the engine.
    14. Fig 4: Identifying Fuel Injection Wiring Harness
    GM2164127Courtesy of GENERAL MOTORS CORP.
  14. Remove the fuel injection wiring harness (1, 2) from the fuel rail and fuel injectors.
  15. If replacing the fuel rail of an injector. Refer to Fuel Injector Replacement .
scientia non olet · About LEMON Manuals