LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2009 >> Escalade EXT >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Starter Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of Starter & Heat Shield
    GM663472Courtesy of GENERAL MOTORS CORP.
  1. If the starter was replaced, install the starter heat shield.
    2. Fig 2: View Of Transmission Cover & Starter
    GM663489Courtesy of GENERAL MOTORS CORP.
  2. If the starter was replaced, snap the transmission cover onto the starter.
    3. Fig 3: View Of Starter Solenoid Cable & Nut
    GM1699544Courtesy of GENERAL MOTORS CORP.
  3. Install the starter through the wheel well opening.
  4. Install the starter solenoid cable to the starter.
    5. CAUTION: Refer to Fastener Caution .
  5. Install the starter solenoid cable nut (1).

    Tighten:  Tighten the cable nut to 9 N.m (80 lb in).

    6. Fig 4: View Of Starter Solenoid Cable Clip & Bolt
    GM1702990Courtesy of GENERAL MOTORS CORP.
  6. Position the starter solenoid cable clip to the frame and install the starter solenoid cable clip bolt (2).

    Tighten:  Tighten the clip bolt to 10 N.m (89 lb in).

    7. Fig 5: View Of Engine Wiring Harness Lead Terminal & Nut
    GM1699540Courtesy of GENERAL MOTORS CORP.
  7. Install the engine wiring harness lead terminal (2) to the starter.
  8. Install the engine wiring harness lead nut (3).

    Tighten:  Tighten the lead nut to 3.4 N.m (30 lb in).

    9. Fig 6: View Of Starter & Bolts (4.8L, 5.3L & 6.0L)
    GM663527Courtesy of GENERAL MOTORS CORP.
  9. Position the starter into place.
  10. Install the starter bolts.

    Tighten:  Tighten the starter bolts to 50 N.m (37 lb ft).

  11. Install the right front wheel and tire. Refer to Tire and Wheel Removal and Installation .
  12. Raise the vehicle.
    13. Fig 7: View Of Engine Wiring Harness Electrical Connector & Components
    GM1698087Courtesy of GENERAL MOTORS CORP.
  13. Connect the engine wiring harness electrical connector (4) to the oil level sensor.
    14. Fig 8: View Of Transmission Cover Bolt
    GM663487Courtesy of GENERAL MOTORS CORP.
  14. Install the transmission cover bolt.

    Tighten:  Tighten the cover bolt to 9 N.m (80 lb in).

  15. Install the oil pan skid plate if equipped, Refer to Oil Pan Skid Plate Replacement (2500/2500 with RPO NZZ) or Oil Pan Skid Plate Replacement (1500 with RPO NZZ) .
  16. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals