Serial Data Gateway Module (SDGM) Reprogramming
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
When SDGM reprogramming must be performed, refer to Service Programming System (SPS) .
Ensure the following conditions exist in order to prepare for SDGM programming or reprogramming:
- The battery is fully charged.
- The ignition switch is in the RUN position.
- The Techline equipment cable connection at the data link connector (DLC) is secure.
Program the SDGM using the latest software matching the vehicle. Refer to up-to-date Techline equipment user instructions.
If the SDGM fails to program, proceed as follows:
- Ensure the DLC and SDGM connections are good.
- Inspect the Techline equipment for the latest software version.
- Attempt to program the SDGM. If the SDGM still cannot be programmed properly, replace the SDGM.