Transfer Case Shift Control Module Reprogramming
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
If the transfer case shift control module needs to be reprogrammed, refer to Service Programming System (SPS) .
Ensure that the following conditions exist in order to prepare for transfer case shift control module programming or reprogramming:
- The battery is fully charged.
- The ignition switch is in the RUN position.
- The Techline equipment cable connection at the data link connector (DLC) is secure.
Program the transfer case shift control module using the latest software matching the vehicle. Refer to up-to-date Techline equipment user instructions.
If the transfer case shift control module fails to program, proceed as follows:
- Ensure that the transfer case shift control module connection is OK.
- Inspect the Techline equipment for the latest software version.
- Attempt to program the transfer case shift control module. If the transfer case shift control module still cannot be programmed properly, replace the transfer case shift control module.