LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2009 >> STS Base, 4.6 A, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Engine Controls And Fuel - 3.6L - Repair Instructions) >> Repair Instructions >> Primary Fuel Level Sensor Replacement >> Removal Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal Procedure

WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the primary fuel tank module. Refer to Primary Fuel Tank Module Replacement .
  2. Fig 1: Fuel Level Sensor Electrical Connector Locking Tab
    GM2030024Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not pull on the connector wires.
  3. Press in the locking tab (1) and disconnect the fuel level sensor electrical connector.
  4. Fig 2: Fuel Level Sensor Electrical Connector
    GM2029120Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the fuel level sensor electrical connector (1).
  6. Fig 3: Fuel Level Sensor Locking Tab
    GM2029133Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not touch the resistor circuit board.
  7. Disengage the locking tab (1) on the fuel level sensor by pushing inward.
  8. Fig 4: Fuel Level Sensor & Stationary Lock
    GM2029159Courtesy of GENERAL MOTORS CORP.
  9. Slide the fuel level sensor (1) upward to the stationary lock (2).
  10. Fig 5: Fuel Level Sensor
    GM2029178Courtesy of GENERAL MOTORS CORP.
  11. Remove the fuel level sensor (1).