LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2010 >> CTS V, Automatic >> Repair and Diagnosis >> Brakes >> Antilock Brake System With Traction Control System & Stability Control System >> Repair Instructions >> Electronic Brake and Traction Control Module with Brake Pressure Modulator Valve Replacement (CTS) >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

    Fig 1: Identifying BPMV & EBCM
    GM1906543Courtesy of GENERAL MOTORS CORP.
  1. Clean the sealing surfaces of the BPMV and the EBCM.
  2. Install the EBCM (1) to the BPMV.
    3. Fig 2: View of EBCM Electrical Connector and Screws
    GM1906542Courtesy of GENERAL MOTORS CORP.
  3. Install the EBCM screws (1).
    4. Fig 3: Installing EBCM To BPMV Screws
    GM782378Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  4. Tighten the EBCM screws in the sequence shown (1-4) to 5 N.m (44 lb in).
  5. Connect the EBCM electrical connector.
  6. Position the washer solvent container and install the fasteners. Refer to Windshield Washer Solvent Container Replacement (With CE4) or Windshield Washer Solvent Container Replacement (Without CE4) .
  7. Install the right front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
  8. Lower the vehicle.
  9. If installing a new EBCM, program the EBCM. Refer to Control Module References .
  10. Perform the Diagnostic System Check - Vehicle .
scientia non olet · About LEMON Manuals