LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2010 >> CTS V, Standard >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 6.2L - Repair Instructions >> Repair Instructions >> Fuel Level Sensor Replacement - Right Side >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: Refer to Gasoline/Gasoline Vapors Warning .
  1. Remove the fuel tank pump module. Refer to Fuel Tank Fuel Pump Module Replacement - Right Side .
    2. Fig 1: Identifying Fuel Level Sensor Electrical Connector Locking Tab
    GM2030024Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not pull on the connector wires.
  2. Press in the locking tab (1) and disconnect the fuel level sensor electrical connector.
    3. Fig 2: Identifying Fuel Level Sensor Electrical Connector
    GM2029120Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the fuel level sensor electrical connector (1).
    4. Fig 3: Identifying Fuel Level Sensor Locking Tab
    GM2029133Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not touch the resistor circuit board.
  4. Disengage the locking tab (1) on the fuel level sensor by pushing inward.
    5. Fig 4: Identifying Fuel Level Sensor & Stationary Lock
    GM2029159Courtesy of GENERAL MOTORS CORP.
  5. Slide the fuel level sensor (1) upward to the stationary lock (2).
    6. Fig 5: Identifying Fuel Level Sensor
    GM2029178Courtesy of GENERAL MOTORS CORP.
  6. Remove the fuel level sensor (1).
scientia non olet · About LEMON Manuals