Circuit/System Verification
- Ignition ON, command the MIL ON and OFF with a scan tool. The MIL should turn ON and OFF as commanded.
- Engine idling, command the MIL ON and OFF with a scan tool while observing the following control circuit status parameters:
- MIL Ckt Short Gnd Test Status
- MIL Ckt Open Test Status
- MIL Ckt Short Volts Test Status
Each parameter should display OK or Not Run.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.