Installation Procedure
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- If reusing the existing inflatable restraint steering wheel module coil it MUST be centered. Refer to Inflatable Restraint Steering Wheel Module Coil Centering .
- Align the inflatable restraint steering wheel module coil (1) with the horn tower on the turn signal switch cancel cam (2).
- Slide the inflatable restraint steering wheel module coil (4) onto the steering shaft (2).
- Firmly seat the new inflatable restraint steering wheel module coil retaining ring (3) into the appropriate groove on the steering shaft (2).
- Remove and discard the centering tab from the new inflatable restraint steering wheel module coil (4).
- Connect any electrical connectors as needed.
- Install the steering column shroud. Refer to Steering Column Shroud Replacement .
- Install the steering wheel. Refer to Steering Wheel Replacement .
- Remove anti-rotation pin J 42640 .
CAUTION:
The new SIR coil assembly will be centered. Improper alignment of the SIR coil assembly may damage the unit, causing an inflatable restraint malfunction.
NOTE:
Do not remove the centering tab from the new inflatable restraint steering wheel module coil until the installation is complete. If the centering tab is missing then re-center the assembly.