LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2011 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1596 (Hybrid Controls - Repair Instructions) >> Repair Instructions >> Drive Motor Generator Control Module Sight Shield Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Sight Shield & Fasteners
    GM1971274Courtesy of GENERAL MOTORS CORP.
    NOTE: The sight shield mounting fastener must be installed and tightened. Failure to properly tighten the sight shield mounting fastener may result in an open High Voltage Interlock Circuit (HVIC) condition and DTCs.
  1. Install the sight shield onto the ball studs (2) and tighten the sight shield mounting fastener (1). Tighten the fastener to 5 N.m (44 lb in).
  2. Install the fender brace. Refer to Front Fender Rear Upper Brace Replacement .
  3. Enable high voltage. Refer to High Voltage Enabling .
scientia non olet · About LEMON Manuals