LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2011 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1811 (Programming And Setup - All Systems) >> Repair Instructions >> Body Control Module Programming and Setup >> Programming the BCM
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Programming the BCM

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

After the procedure is completed, the personalization settings of the BCM are set to default settings. Inform the customer that the personalization must be set again.

To program and setup an existing or new replacement Body Control Module, perform the following procedure:

  1. Access the Service Programming System (SPS) and follow the on-screen instructions. Refer to Service Programming System (SPS) .
  2. On the SPS Supported Controllers screen, select BCM Body Control Module - Programming and Setup and follow the on-screen instructions.
NOTE:

After programming, perform the following to avoid future misdiagnosis:

  1. Turn the ignition OFF for 10 seconds.
  2. Connect the scan tool to the data link connector.
  3. Turn the ignition ON, with the engine OFF.
  4. Use the scan tool in order to retrieve history DTCs from all control modules.
  5. Clear all history DTCs.
scientia non olet · About LEMON Manuals