Removal Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Refer to Brake Fluid Irritant Caution
.
NOTE:
Refer to Brake Fluid Effects on Paint and Electrical Components Notice
.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove all dirt and debris from the electronic brake control module (EBCM) and the brake pressure modulator valve (BPMV) before loosening or removing any of the components.
- Using denatured alcohol, clean the EBCM (2) and the BPMV (3).
- Disconnect the EBCM electrical connector.
- Remove and discard the EBCM to BPMV screws (1).
- Carefully pull the EBCM (2) from the BPMV (3).
- Remove the EBCM to BPMV gasket.
IMPORTANT:
DO NOT reuse the EBCM to BPMV screws. Install NEW screws.