Vehicle Direction Alert Alarm Warning Module Programming and Setup

After replacing the vehicle direction alert alarm warning (VDAAW) module, perform the following procedures in the specified order:

IMPORTANT:

When using SPS to program the VDAAW, connect the vehicle to the TIS terminal using a Candi module, Tech 2, and RS232 cable. Using the MDI to SPS program the VDAAW will result in a failure to complete the programming operation.

1. SPS Programming - Refer to Service Programming System (SPS) 
2. VDAAW Module Calibration - Refer to Vehicle Direction Alert Alarm Warning Module Calibration