Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying BPMV & EBCM

Courtesy of GENERAL MOTORS CORP.

Clean the sealing surfaces of the BPMV and the EBCM.
Install the EBCM (1) to the BPMV.

Fig 2: View of EBCM Electrical Connector and Screws

Courtesy of GENERAL MOTORS CORP.

Install the EBCM screws (1).

NOTE: Refer to Fastener Notice .

Fig 3: View of Tightening Sequence on EBCM

Courtesy of GENERAL MOTORS CORP.

Tighten the EBCM screws in the sequence shown (1-4).
Tighten: Tighten the screws to 3 N.m (26 lb in).
Connect the EBCM electrical connector.
Position the washer solvent container and install the fasteners. Refer to Windshield Washer Solvent Container Replacement (Minus CE4) or Windshield Washer Solvent Container Replacement (With CE4) .
Install the front air deflector shield. Refer to Front Air Deflector Replacement .
Lower the vehicle.
If installing a new EBCM, program the EBCM. Refer to Control Module References .
Perform the Diagnostic System Check - Vehicle .