Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install the relay rod (5) to the vehicle.
- Install the pitman arm (2) to the relay rod (5).
- Install the idler arm (1) to the relay rod (5).
- Install the pitman arm nut (4).
Tighten: Tighten the nut to 62 N.m (46 lb ft).
- Install the idler arm nut (6).
Tighten: Tighten the nut to 62 N.m (46 lb ft).
- Install the steering linkage inner tie rods (3). Refer to Steering Linkage Inner Tie Rod Replacement .
- Install the steering linkage shock absorber to the relay rod, if equipped. Refer to Steering Linkage Shock Absorber Replacement .
- Install the engine shield, if equipped. Refer to Engine Shield Replacement .
- Adjust the front toe. Refer to Front Toe Adjustment .
NOTE:
Refer to Fastener Notice
.
IMPORTANT:
Use a new pitman arm nut.
IMPORTANT:
Use a new idler arm nut.