Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install a stationary window into the opening. Refer to Urethane Adhesive Installation of Stationary Windows (Quarter Window) or Urethane Adhesive Installation of Stationary Windows (Windshield) .
- Install the window side reveal moldings to the vehicle.
- Install the screws to the left and the right sides of the window side reveal moldings.
Tighten: Tighten the screws to 2 N.m (18 lb in).
- Install the front door sealing weatherstrips (1) to the retainer (2).
- Install the cowl air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
- Install the window wiper arms. Refer to Wiper Arm Replacement .
- Install the antenna mast, if equipped. Refer to Fixed Antenna Replacement (Avalanche/Escalade EXT) .
- Install the outside moisture sensor. Refer to Windshield Outside Moisture Sensor Replacement .
- Install the inside rearview mirror. Refer to Rearview Mirror Replacement .
- Close the hood.
- Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
NOTE:
Refer to Fastener Notice
.