LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2012 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 841 (Steering Linkage) >> Repair Instructions >> Relay Rod Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Relay Rod & Components
    GM340481Courtesy of GENERAL MOTORS CORP.
  1. Install the relay rod (9) to the vehicle.
  2. Connect the pitman arm ball stud (2) to the relay rod.
  3. Connect the idler arm ball stud (1) to the relay rod.
  4. Install the new pitman arm prevailing torque nut.
    5. NOTE: Refer to Fastener Notice .
  5. Install the new idler arm prevailing torque nut.

    Tighten:  Tighten the nuts to 62 N.m (46 lb ft).

  6. Install the inner tie rod ends. Refer to Tie Rod Replacement - Inner .
  7. Install the steering damper to the relay rod, if equipped. Refer to Steering Damper Replacement .
  8. Install the engine protection shield, if equipped. Refer to Engine Shield Replacement .
  9. Lower the vehicle.
  10. Check the wheel alignment. Refer to Measuring Wheel Alignment .
scientia non olet · About LEMON Manuals