LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2013 >> XTS AWD >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Repair Instructions >> Electronic Parking Brake Control Module Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

  1. Block the drive wheels.
  2. Disable the parking brake cable adjuster. Refer to Parking Brake Cable Adjuster Disabling 
  3. Place the ignition in the OFF position.
  4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  5. Remove the left rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (With J64) , Tire and Wheel Removal and Installation (With J55) .
  6. Remove the left rear wheelhouse panel liner. Refer to Rear Wheelhouse Liner Replacement .
    7. Fig 1: Parking Brake Cable Nut
    GM2752677Courtesy of GENERAL MOTORS COMPANY
  7. Remove the parking brake cable nut (1).
  8. Disconnect the electronic parking brake control module electrical connector.
    9. Fig 2: Electronic Parking Brake Control Module Nuts
    GM2752681Courtesy of GENERAL MOTORS COMPANY
  9. Remove the electronic parking brake control module nuts (1).
  10. Remove the electronic parking brake control module and bracket assembly.
  11. Remove the electronic parking brake control modulator bracket, if necessary. Refer to Electronic Parking Brake Control Modulator Bracket Replacement .
scientia non olet · About LEMON Manuals