Replace and Program Control Module or Reprogram Control Module

WARNING: This page is about a different car, the 2013 Cadillac XTS. However, it is still accessible from the selected car via links, so may be relevant.

To program a replacement or an existing control module, perform the following procedure:

Without Rear Seat Video Entertainment System

This control module does not require SPS programming or any setup procedures.

With Rear Seat Video Entertainment System

Install the EL-49642 SPS Programming Support Tool.
Connect a USB drive to the computer.
Access the Service Programming System (SPS) and follow the on-screen instructions.
On the SPS Supported Controllers screen, select Media Disc Player - USB File Transfer and follow the on-screen instructions.
Upon completion of the file transfer, remove the USB drive from the computer.
Ignition ON, infotainment system ON.
Connect the USB drive to the USB port in the vehicle.
The infotainment system will recognize that update files are available. Follow the infotainment display on-screen instructions and select Update when prompted. Programming will take several minutes.
Upon completion of programming, remove the USB drive. Follow the infotainment display on-screen instructions.
On the SPS Supported Controllers screen, select Media Disc Player - Programming and follow the on-screen instructions.
At the end of programming, choose the "Clear All DTCs" function on the SPS screen.