Unsuccessful Programming Recovery

If programming a control module is not successful, perform the following procedure:

1. Verify the control module, data link connector and programming tool connections are secure and the SPS software is up to date.
2. Ignition On/Vehicle in Service Mode.
3. Perform the SPS function:Reprogram ECU<!--T2W2-->

   Verify the control module programming is successful.

   • If the programming is not successful 
   1. Ignition/Vehicle Off for greater than <p01> min.
   2. Ignition On/Vehicle in Service Mode.
   3. Perform the SPS function:Reprogram ECU<!--T2W2-->
      • If the programming is not successful, replace the component: K71 Transmission Control Module
      • If the programming is successful
   4. All OK.
   • If the programming is successful 
4. All OK..