LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2016 >> CTS V >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 6.2L (LT4) - Repair Instructions >> Repair Instructions >> Camshaft Position Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Install the NEW O-ring seal (2)
    Fig 1: Camshaft Position Sensor And Seal
    GM4088529Courtesy of GENERAL MOTORS COMPANY
  2. Install the camshaft position sensor (1) into the engine front cover.
  3. Position the camshaft position sensor bracket and sensor wiring harness (1) in place.
    Fig 2: Sensor Wiring Harness
    GM4088484Courtesy of GENERAL MOTORS COMPANY
  4. Connect the oil pump flow control valve connector (1), camshaft position actuator solenoid connector (2), camshaft position sensor connector (3) and the engine wiring harness connector (4).
    Fig 3: Oil Pump Flow Control Valve Connector, Camshaft Position Actuator Solenoid Connector, Camshaft Position Sensor Connector And Engine Wiring Harness Connector
    GM4087697Courtesy of GENERAL MOTORS COMPANY
  5. Install the camshaft position sensor bracket fasteners (1) and tighten to 25 N.m (18 lb ft).
    Fig 4: Camshaft Position Sensor Bracket Fasteners
    GM4087708Courtesy of GENERAL MOTORS COMPANY
    CAUTION: Refer to Fastener Caution
  6. Engine Oil Cooler Hose/Pipe Replacement (LT4) » Install
  7. Supercharger Belt Idler Pulley Replacement (Supercharger Belt Tensioner Bracket)Supercharger Belt Idler Pulley Replacement (Engine Coolant Manifold - Upper)Supercharger Belt Idler Pulley Replacement (Engine Coolant Manifold - Lower) » Install
  8. Air Cleaner Outlet Duct Replacement » Install
  9. Intake Manifold Cover Replacement - Front » Install
scientia non olet · About LEMON Manuals