Fastener Specifications
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.
|
|---|
| Application |
| Differential Carrier Cover Seal |
| Rear Axle Shaft Retaining Clip |
| Rear Wheel Drive Shaft Flange Ring |
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.
|
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Rear Wheel Drive Shaft Flange Nut | |
|
Tighten nut slowly until pinon endplay is just taken up. |
|
0.40-0.57 N.m (36-60 lb in) of rotational torque. |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal.
|
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Differential Carrier Cover Bolts (200 mm Axle) | 38 N.m (28 lb ft) |
| Differential Carrier Cover Bolts - Torx® Bolts (225 mm Axle) | 105 N.m (77 lb ft) |
| Differential Carrier Cover Bolts - Hex Bolts (225 mm Axle) | |
|
90 N.m (66 lb ft) |
|
plus 40 degrees |
| Differential Carrier Cover Bolt - Left Side (226 mm eLSD) | 52 N.m (38 lb ft) |
| Differential Carrier Front Mounting Bolts | |
|
50 N.m (37 lb ft) |
|
plus 90 degrees |
| Differential Carrier Rear Mounting Bolt | |
|
220 N.m (162 lb ft) |
|
plus 60 degrees |
| Differential Clutch Cover Plug | 19 N.m (14 lb ft) |
| Drain Plug (200/225 mm Axle) | 45 N.m (33 lb ft) |
| Drain Plug (226 mm eLSD) | 33 N.m (24 lb ft) |
| Fill Plug (200/225 mm Axle) | 45 N.m (33 lb ft) |
| Fill Plug (226 mm eLSD) | 33 N.m (24 lb ft) |
| Limited Slip Differential Clutch Bolt | 20 N.m (15 lb ft) |
| Limited Slip Differential Clutch Pipe Connector - Female 16 mm | 28 N.m (21 lb ft) |
| Limited Slip Differential Clutch Pipe Connector - Male 18 mm | 31 N.m (23 lb ft) |
| Limited Slip Differential Clutch Valve Bolt | 3 N.m (27 lb in) |
| Oil Cooler Fittings - 19 mm (225 mm mLSD Axle) | 22 N.m (16 lb ft) |
| Rear Axle Vent (200/225 mm Axle) | 50 N.m (37 lb ft) |
| Rear Axle Vent (226 mm eLSD) | 10 N.m (89 lb in) |