Circuit/System Verification
NOTE:
Verify that all harness connectors are properly connected and free of damage or corrosion.
- Ignition ON.
- Verify DTC C056D is not set.
- If DTC C056D is set with symptom byte 34, 35, or 3C
- Program the K43 Power Steering Control Module.
- Verify the DTC does not set.
- If the DTC sets, replace the K43 Power Steering Control Module.
- If the DTC does not set
- All OK.
- If DTC C056D is set with symptom byte 36, 37, 38, 39, or 3B
Replace the K43 Power Steering Control Module
- If DTC C056D is not set
- All OK