LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2017 >> CTS Base, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 2.0L (LTG) - Repair Instructions >> Repair Instructions >> Fuel Tank Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Install the following components if fuel tank replacement was necessary:
    1. Fuel tank fuel pump module. Refer to Fuel Tank Fuel Pump Module Replacement .
    2. Fig 1: Fuel Tank
    GM2815733Courtesy of GENERAL MOTORS COMPANY
  2. Use a suitable jack and install the fuel tank (1).
    3. Fig 2: Fuel Tank Straps And Bolts
    GM2815736Courtesy of GENERAL MOTORS COMPANY
  3. Install the fuel tank straps (2).
    4. CAUTION:

    Refer to Fastener Caution .

  4. Install the fuel tank strap bolts (1) and tighten to 20 N.m (15 lb ft).
    5. Fig 3: Evaporative Emission And Fuel Pipes
    GM2815749Courtesy of GENERAL MOTORS COMPANY
  5. Connect the evaporative emission and fuel pipes (2). Refer to Plastic Collar Quick Connect Fitting Service .
  6. Connect the fuel tank electrical connector.
  7. Install the two piece propeller shaft. Refer to Two-Piece Propeller Shaft Replacement (LT4, LTG) .
  8. Install the left rear suspension bracket. Rear Suspension Bracket Replacement (Front)Rear Suspension Bracket Replacement (Rear)
  9. Install the left and right side rear air deflectors. Refer to Underbody Rear Air Deflector Replacement - Left Side , and Underbody Rear Air Deflector Replacement - Right Side .
  10. Refill the fuel tank.
  11. Inspect for fuel leaks.
scientia non olet · About LEMON Manuals