Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Electronic Brake Control Module (1) - Install
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Fastener Caution

Electronic Brake Control Module Bolt (1) - Install and tighten [4x] 3 N.m (27 lb in)
Courtesy of GENERAL MOTORS COMPANY

Brake Pressure Modulator Valve Primary Brake Pipe Fitting (1) - Install - Brake Pressure Modulator Valve Pipe Replacement (LTG Without HP9)Brake Pressure Modulator Valve Pipe Replacement (LGW, LGX)
Connect the EBCM electrical connector.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Some components not shown for graphic clarity.

Chassis Front Wiring Harness (2) - Install
Chassis Front Wiring Harness Clip Nut (1) - Install and tighten 9 N.m (80 lb in)
Engine Wiring Harness Fuse Block Bracket - Install - Engine Wiring Harness Fuse Block Bracket Replacement
Bleed the brake system. Antilock Brake System Automated Bleed
Program the EBCM. Control Module References
Center the steering angle sensor. Steering Wheel Angle Sensor Centering (without UKL) Steering Wheel Angle Sensor Centering (with UKL)