Installation Procedure
Battery Positive Cable(4) - Install[3X]
- Battery Positive Cable Nut(2) - Install and tighten[2X] 9 N.m (80 lb in)
- Battery Positive Cable Nut(1) - Install and tighten 12 N.m (106 lb in)
- Battery Positive Cable Retainer(3) - Engage
Close the battery fuse block cover.(2)
- Battery Distribution Fuse Block Retaining Tab(1) - Engage
Battery Positive Cable Retainer(1) - Engage[2X]
Battery Positive Cable(3) - Install
- Generator Positive Cable Fastener(1) - Install and tighten 15 N.m (11 lb ft)
- Protective Cap(2) - Install
- Raise and support the vehicle. Lifting and Jacking the Vehicle
Battery Positive Cable(2) - Install
- Starter Solenoid Cable Nut(1) - Install and tighten 12.5 N.m (111 lb in)
- Battery Positive Cable Conduit Fastener (3) - Install and tighten 9 N.m (80 lb in)
Starter Heat Shield(2) - Install - Starter Shield Replacement
- Lower the vehicle.
- Connect the negative battery cable. Battery Negative Cable Disconnection and Connection
CAUTION:
Refer to Fastener Caution