Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Electrical Connector(1) - Connect
Install the starter.(2)
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution

Starter Mounting Bolt(1) - Install and tighten[2X] 58 N.m (43 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Battery Positive Cable(2) - Install
Starter Solenoid Cable Nut(1) - Install and tighten 12.5 N.m (111 lb in)
Battery Positive Cable Conduit Fastener (3) - Install and tighten 9 N.m (80 lb in)
Courtesy of GENERAL MOTORS COMPANY

Knock Sensor- Bank 2(1) - Install - Knock Sensor Replacement - Bank 2
Courtesy of GENERAL MOTORS COMPANY

Starter Heat Shield(2) - Install - Starter Shield Replacement
Warm Up Three-Way Catalytic Converter- Bank 2 - Install - Warm Up Three-Way Catalytic Converter Replacement (Bank 1, LGX)Warm Up Three-Way Catalytic Converter Replacement (Bank 2, LGX)
Lower the vehicle.
Connect the negative battery cable. Battery Negative Cable Disconnection and Connection