Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Position the electronic parking brake control module (1) to the electronic parking brake control module bracket.
Inspect the O-ring seals on the spindle and the intermediate cable for damage and correct positioning and replace, if necessary.
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

NOTE:
When installing the electronic park brake intermediate cable nut to the electronic park brake module spindle, hold the spindle housing securely to avoid distorting the housing.

Install the parking brake intermediate cable nut (1) and tighten to 6 N.m (53 lb in).
Maneuver and install the electronic parking brake control module and bracket to the rear suspension support.
Connect the electronic parking brake control module electrical connector.
Courtesy of GENERAL MOTORS COMPANY

Install the electronic parking brake control module bracket bolts (1) and tighten to 9 N.m (80 lb in).
Courtesy of GENERAL MOTORS COMPANY

Install the electronic parking brake control module bolts (1) and tighten to 7 N.m (62 lb in).
Program the electronic parking brake control module. Refer to Control Module References .