Replace and Program Frontview Camera Module or Reprogram Frontview Camera Module (with UGN)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2020 GMC Yukon XL, 2020 GMC Yukon, 2020 Chevrolet Tahoe, 2020 Chevrolet Suburban, and 2020 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
To program a replacement or an existing B174W Frontview Camera - Windshield, perform the following procedure:
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select B174W Frontview Camera - Windshield - Programming and follow the on-screen instructions.
- If reprogramming an existing module that was previously calibrated, calibration is not required. The module retains its calibration settings during reprogramming. If a new module was programmed the module alignment must be calibrated. Using a scan tool, initiate the learn procedure for B174W Frontview Camera - Windshield. The scan tool must remain connected and on the calibration screen during the entire process.
Refer to Front View Camera Module Learn .
NOTE:
After programming is performed, it is normal to have DTC B101E 4B set until calibration is complete.