Replace and Program Frontview Camera Module or Reprogram Frontview Camera Module (without UGN)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2020 GMC Yukon XL, 2020 GMC Yukon, 2020 Chevrolet Tahoe, 2020 Chevrolet Suburban, and 2020 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Due to continuous improvements, the on screen selections may vary from instructions below.
To program a replacement or an existing Front View Camera Module, perform the following procedure:
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select B174W Frontview Camera - Windshield - Programming and follow the on-screen instructions.
- At the end of programming, choose the "Clear DTCs" function on the SPS screen.
- Following B174W Frontview Camera - Windshield replacement and reprogramming, the module must be calibrated. Refer to Front View Camera Module Learn .