Replace and Program ECU or Reprogram ECU
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2020 GMC Yukon XL, 2020 GMC Yukon, 2020 Chevrolet Tahoe, 2020 Chevrolet Suburban, and 2020 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
To program a replacement or an existing ECU, perform the following procedure:
NOTE:
- Due to continuous improvements, the on screen selections may vary from instructions below.
- It is recommended to program both the left and right (if programmable) when a programming event is required.
- Some systems only have one programmable Side Object Sensor Module.
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select B218L/R Side Object Sensor Module or B218R Right Side Object Sensor Module or B218L Left Side Object Detection.
- On the SPS Select Function/Sequence screen, select Sequential Programming or Programming
- At the end of programming, choose the "Clear DTCs" function on the SPS screen.