Distance Sensing Cruise Control Module Replacement
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2020 GMC Yukon XL, 2020 GMC Yukon, 2020 Chevrolet Tahoe, 2020 Chevrolet Suburban, and 2020 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
If the cruise control vehicle distance sensor module needs to be replaced, the following procedures must be performed:
- Replace the K14 Distance Sensing Cruise Control Module. Refer to Forward Range Radar Module Replacement (Chevrolet, GMC) , or Forward Range Radar Module Replacement (Cadillac)
- Align the K14 Distance Sensing Cruise Control Module. Refer to Forward Range Radar Module Alignment (Chevrolet, GMC)
- Install EL-49642 SPS Programming Support Tool.
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select K14 Distance Sensing Cruise Control Module.
- Perform the SPS function Distance Sensing Cruise Control Module - Programming and follow the on-screen instructions.
- Perform the SPS function Distance Sensing Cruise Control Module - Configuration and follow the on-screen instructions.
- DTC C056E with failure type byte 4B will set as a result of the programming event.
- Perform the Distance Sensing Cruise Control Module learn procedure. Refer to Distance Sensing Cruise Control Module Learn
- At the end of programming, choose the "Clear All DTCs" function on the SPS screen.