LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2020 >> XT6 Sport >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Programming And Setup) >> Repair Instructions >> K71 Transmission Control Module: Programming and Setup (10L80 (MF6)) >> Programming an Existing or New Control Module
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Programming an Existing or New Control Module

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2020 GMC Yukon XL, 2020 GMC Yukon, 2020 Chevrolet Tahoe, 2020 Chevrolet Suburban, and 2020 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.

To program an existing or new control module, perform the following procedure:

  1. Install the special tool: EL-49642 SPS Programming Support Tool
  2. Ignition - On/Vehicle - In Service Mode
  3. Access SPS and follow the on-screen instructions for the control module: K71 Transmission Control Module
    1. Select - Programming
    2. Select - MCVM Operations - If applicable
    3. Ignition/Vehicle - Off - For greater than 2 min
    4. Select - Setup - Follow the on-screen instructions.
  4. Clear DTCs after programming is complete. Clearing powertrain DTCs will set the Inspection/Maintenance (I/M) system status indicators to No.
  5. All OK.
scientia non olet · About LEMON Manuals