Replace and Program Control Module or Reprogram Control Module - With Night Vision Camera Replacement
WARNING: This page is about a different car, the 2020 Cadillac XT5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Reprogram the Night Vision Camera Control Module when the Night Vision Camera is replaced. If the same camera has been removed and installed, perform Night Vision Camera Control Module Learn .
To program a replacement or an existing control module, perform the following procedure:
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select K172 Night Vision Camera Control Module - Programming and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select K172 Night Vision Camera Control Module - Setup to enable Night Vision Calibration. Refer to Night Vision Camera Control Module Learn .
- At the end of programming, choose the "Clear All DTCs" function on the SPS screen.