Unsuccessful Programming Recovery

In the event of an interrupted or unsuccessful programming event, perform the following steps:

1. Ignition ON. Ensure the active safety control module, DLC and programming tool connections are secure and the SPS software is up to date.
2. Verify the K124 Active Safety Control Module can be reprogrammed.
   • If the K124A Active Safety Control Module 1 or K124B Active Safety Control Module 2 cannot be reprogrammed 
   1. Ignition OFF for one minute, ignition ON.
   2. Verify the appropriate K124 Active Safety Control Module can be reprogrammed.
      • If the active safety control module cannot be reprogrammed, replace the appropriate K124 Active Safety Control Module.
      • Go to next step: If the K124 Active Safety Control Module can be reprogrammed.
   3. All OK.
   • Go to next step: If the K124 Active Safety Control Module can be reprogrammed 
3. All OK.