Code 12 - No Distributor Reference Pulses
Code 12 indicates the ECM is on and sees no reference pulse from the distributor. This is a normal code with the ignition on and the engine not running. Code 12 is not stored and will only flash when the fault is present. With engine running, Code 12 could mean an open or ground in distributor reference circuit. Code 41 will appear with Code 12 if engine is running with no distributor reference signal. If problem clears, Code 41 will store.
NOTE:
The following step numbers refer to the numbers in the accompanying flow chart(s).
- This test checks for a poor connection at EST connector as being the cause of no reference pulse. Check for corrosion, connector terminals not fully seated or terminal not properly attached to wire. Terminal must be removed from the connector and carefully inspected.
- Voltage should normally be more than .5 volt, indicating that the signal is being generated by the module and fault is a bad connection at the ECM, or faulty ECM. To check ECM connection, terminal must be removed from connector.
- If circuit from terminal "10" to module is not open or grounded, source of no signal is the module.