Power Steering General Servicing: Testing: Preparation

With belt tension correct, disconnect power steering pump pressure hose. See BELT TENSION table. Keep hose end raised to prevent fluid loss. Connect pressure hose of gauge to power steering pump fitting. Connect other hose from valve side of tester to steering gear inlet.
Open valve. Run engine until fluid reaches normal operating temperature of 170°F (77°C). Check fluid level. Add fluid (if necessary).

BELT TENSION ⁽¹⁾

Application

New Belt

Used Belt

V-Belt

146

⁽¹⁾	Tension in Lbs. Using Boroughs Tension Gauge. Serpentine belts are equipped with self-tensioner.