LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 1989 >> Corvette 2D Convertible, Standard >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Anti-Theft System - Vats (Pass Key) >> Testing >> Decoder Module Test >> Resistance Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Resistance Test

  1. Using DECODER MODULE TERMINAL RESISTANCE  table below, measure at decoder module connector (with it disconnected). Disconnect negative battery cable. If resistances check good but engine will not crank, replace Pass Key decoder module.
    DECODER MODULE TERMINAL RESISTANCE (1)

    Measure Between (2) Voltage Specifications
    "B2" (YEL) & "A6" (BRN) (3) Infinity
    "B2" (YEL) & "A6" (BRN) (4) 380 to 12.3k
    (1) Decoder module connector & negative battery cable disconnected.
    (2) See Figure & 6 for terminal identification and color.
    (3) Without key in the ignition.
    (4) With key in the ignition.
  2. If resistance between "B2" (YEL) and "A6" (BRN) without key in ignition is not within specifications, check "B2" (YEL) and "A6" (BRN) wires for short to ground or between the 2 wires.
  3. If resistance between "B2" (YEL) and "A6" (BRN) with key in ignition is not within specifications, check "B2" (YEL) and "A6" (BRN) wires for an open.
scientia non olet · About LEMON Manuals