Disassembly (Model TC)
- Clamp front hub in soft-jawed vise. Pry tab outward and remove reservoir clips (if equipped). See Figure . Remove reservoir or return tube and "O" ring. Using Puller (J-29785-A) remove pulley from shaft if not previously removed.
- Remove fitting, "O" ring, flow control valve and spring. Note location of beveled side of snap ring. Remove snap ring, drive shaft and bearing. See Figure . Using screwdriver, remove drive shaft seal from housing. Remove retaining ring by inserting punch into access hole and disengage retaining ring.
- Using a brass drift, tap on thrust plate and remove. Remove "O" ring, pump ring, rotor and vanes. Remove dowel pins, pressure plate, "O" ring and pressure plate spring. Remove "O" ring, dowel pin and sleeve.