Manifold Absolute Pressure (Map) Sensor

The MAP sensor measures changes in manifold pressure. Changes in manifold pressure result from engine load and speed changes. The MAP sensor converts these changes in manifold pressure into a voltage output signal to ECM (1.5 volts at idle to 4.5 volts at WOT). The ECM can monitor these signals and adjust air/fuel ratio and ignition timing under various operating conditions.

If MAP sensor fails, the ECM substitutes a fixed MAP value, and uses the TPS to control fuel delivery. A fault in the MAP circuit should set a related trouble code. If a related trouble code is not present and MAP sensor is suspected of causing a driveability problem, perform functional check of MAP sensor. See SYSTEM/COMPONENT TESTS article in this section.