Scan Data Parameters
Only parameters listed in SCAN DATA PARAMETERS table should be used when diagnosing ABS. If other data is received, it should not be considered reliable and scan tester should be repaired or replaced.
SCAN DATA PARAMETERS
| Scan Position | Unit Displayed | ||
|---|---|---|---|
| ABS Battery Voltage | Volts | ||
| ABS Ignition Voltage | Volts | ||
| ANTI-LOCK Warning Light | On-Off/Flashing | ||
| Brakes Available | Anti-Lock/Base Brakes | ||
| Brake T-Tale CMD | On-Off | ||
| Brake Tell-Tale CMD | On-Off Circuit Open | ||
| Brake Switch | On-Off Circuit Open | ||
| Enable Relay CMD | On-Off | ||
| Front WHL Speeds | MPH-km/h | ||
| Left Front Solenoid | On-Off | ||
| Left Front EMB | Release/Hold | ||
| Left Front Motor Command FWD/REV | Amps | ||
| Left Motor Feedback | Amps | ||
| Right Front Motor Command FWD/REV | Amps | ||
| Right Motor Feedback | Amps | ||
| Rear Motor Command FWD/REV | Amps | ||
| Rear Motor Feedback | Amps | ||
| Rear WHL Speeds | MPH-km/h | ||
| Right Front Solenoid | On-Off | ||
| Right Front EMB(1) | Release/Hold | ||
| Vehicle Speed | MPH-km/h | ||
|
|||