Cycling CCM Outputs

Cycling CCM outputs on and off is used to determine if circuits and components are properly operating.
To enter cycling CCM outputs function, press TRIP/ODO (next test) button on DIC until "1.4" displays on trip monitor. Press ENG/MET (next value) button until identifying number for component to be cycled is displayed in the first 2 digits of odometer. See CCM OUTPUT IDENTIFICATION NUMBER table. Press FUEL INFO (previous value) button to go backward in the list.
Output status cycling is displayed in the last digit of odometer. Output status will display as "1" (on) or "0" (off). Output will cycle between on and off every 3 seconds.

CCM OUTPUT IDENTIFICATION NUMBER

Output ID No.

Output

Change Oil Indicator

02 ⁽¹⁾

Check Gauges Indicator

Fasten Seat Belt Indicator

Security Light Indicator

High Beam Indicator

Chime No. 1

Chime No. 2

LCD Blanking Control

Rear Defogger Relay

Courtesy Light Relay

Low Oil Indicator

12 ⁽²⁾

Start Enable Relay

Delayed Accessory Bus Relay

Horn Relay

⁽¹⁾	Engine must be running for indicator to cycle. Indicator will illuminate without engine running because gauges this indicator monitors will be out of correct range.

⁽²⁾	Start Enable relay output will only be cycled if proper PASS-Key(R) is in ignition, or if PASS-Key(R) is unprogrammed.